vortex

We’ve had a huge demand to run this class again this spring, so we’ve finally added this open enrollment class to our calendar. Here is your chance to keep up on the latest equipment and trends in the rope rescue world.

Join us in Pennsylvania Dutch country for our latest presentation of Modern Technologies in Rope Rescue at the  Lancaster County Public Service Training Center on April 25 and 26 2015. Using the newest techniques on the newest equipment in an urban setting, come learn ideas that have been proven and tested in the real world in both urban and wilderness settings.

Topics included this time around include:

Use of the AZTEK kit to pass knots, perform a pickoff, basket attending, and a whole lot more.

In depth discussion and use of the Two Tension Rope System utilizing the MPD.

Use of  the Arizona Vortex  high directional in the urban environment.

The Rescue 2 Training original: The Appalachian Doortex! For urban anchoring and elevator rescue. High Directional? Anchor? Both!?… Come find out!

3 dimensional anchoring with the UFO.

The Skyhook capstan winch.

…And much more.

The cost of this two day, 16 hour class is $295 per person. Just bring a harness, helmet, and any ideas or equipment you would like to see used.

Please contact Kelly Byrne at 240-462-6610 or kelly@rescue2training.com for registration information or questions.

 

azorp gin poleIMG_0221IMG_0211

 

IMG_7687IMG_1428IMG_1415IMG_1419

Learning from others’ mistakes is something we can and should do, particularly when it pertains to rescue work. The situations below are prime examples of this. Take a minute to laugh a little at their misfortune (I’m pretty sure nobody died), but then try and absorb what happened and make sure it doesn’t happen to you.

The first example of things going bad could have been solved by a couple of easy solutions like: knowing how to tie a knot, having somebody who knows how to tie a knot look over your system, use a backup line that is tied with an appropriate knot, etc… There’s a trend there somewhere.

Knowing how your system is going to react when acted upon is a REALLY good skill to have when performing rope rescue operations. See if you can figure out what is going to happen in the video below when the helicopter pulls up to lift the rescue package:

 

Here at Rescue 2 Training we are pretty big fans of getting our rope systems up off of the ground for the edge transition. Combine a low rope over the edge with not knowing what your rope system is going to do when you load it (as mentioned above) and you have recipe for a bad time. Here is what the finished, face smashing product (and Bad Edge Transition Hall of Fame member) looks like when you pull it out of the oven:

 

We have just added an Open Enrollment Class for our Modern Technologies in Rope Rescue workshop on May 17 and 18 in Lancaster, PA.This class covers a lot of ground in two days. We will discuss and use the AZTEK in many of its essential uses. We’ll also be using the Two Tension Rope System concept with the CMC MPD. Additionally, we’ll be using the Arizona Vortex in some of its traditional configurations as well as the Rescue 2 Training original: the “Appalachian Doortex” configuration for urban anchoring and elevator rescue.

Come out and try the newest equipment and techniques in rope rescue. Cost of the class is $295.

Email Kelly M Byrne at kelly@rescue2training.com or call 240-462-6610 for more information.

open enrollment lancaster may 2014.001ufo 2ufo 1
mpd 1

Enrollment is now open for our Modern Technologies in Rope Rescue. The class will be held August 24 and 25 at the Lancaster County Public Service Training Center in Lancaster County, PA at a cost of $295 per student.

This class covers multiple versions of the bowline along with some pretty god reasons to consider them, several uses of the AZTEK kit, a thorough introduction to the Two Tension Rope System concept with the MPD, and the use of the Arizona Vortex Artificial High Directional in some pretty typical urban setup configurations as well as some Rescue 2 Training exclusive uses of it in a few of the Appalachian Doortex configurations. As you can see in the pictures below from our last class, we did a good bit of work with the Rock Exotica UFO. One particularly challenging and fun scenario was to change the direction of our main and belay lines 180 degrees on an anchor that was free floating in the middle of the stair landing. There was also some excellent use of the UFO to simplify the rigging of a Two Rope Offset.

In addition to the Arizona Vortex, Appalachian Doortex, MPD’s, UFO’s, and AZTEK’s, we’ll also have available for use in this class three new products (some not even on the market yet) from Rock Exotica:

The little brother of the UFO; the rockStar.

The Enforcer load cell; which features swivels at both ends, a digital readout, and Bluetooth transmitting capabilities!

The AZORP (Arizona Omni Rigging Pod); an add on used to increase the already amazing flexibility of the Arizona Vortex.

open enrollment August 2013

Here are some pictures from our last MTRR class; we did some heavy duty 3D rigging along with some urban AZV usage:

IMG_1408 IMG_1412 IMG_1420 IMG_1429 IMG_1432 IMG_1434 IMG_1393

This class is different each time we run it and we’ve developed new techniques each class with input and ideas from the students. If you’re interested in seeing and helping develop what’s on the cutting edge of rope rescue equipment and techniques, contact Kelly to reserve a spot in this popular class. Call 240-462-6610 or send an email to rescue-2@comcast.net

Well, after finally getting off of a 3 month ambulance rotation on “The Soulcrusher”, I’m hoping to be back in the swing of regular posts here on the website. In the vein of getting back in the swing, here are a few unique things related to ropes and swings:

First up is the world’s most expensive swingset, probably the most portable, but you’ve got to pay for the privilege.  I try to keep my hands on rope at least once a day; since this day was so beautiful, I decided to take out the ol’ Arizona Vortex and goof around a bit. Because there is no cliff in my yard (yet), I had to settle for a flat land configuration. I used my AZV, a couple of AZTEK’s, a bosun’s chair, and a 4 year old. Here’s the result:

IMG_7122

Of a more daring nature is the rope swing as pioneered by rock climber Dan Osman. While he ultimately died doing one of these jumps, it is pretty neat to watch the cajones this guy has to be able to do this stuff. He basically sets up a highline and, with a separate rope attached mid span, takes a free fall jump perpendicular to the track line. When the separate rope he is attached to comes tight, he goes for one hell of a long swing. I guess that, with the rope stretch and moveable mid span anchor, this is greater than a FF 2. If anybody agrees or disagrees, I’d love to know.

In stark contrast to Dan, I present the world’s slowest, yet safest, rope swing. Here is a shot of the rope offset that we set up in the last “Modern Technologies” class in Lancaster, PA.  We had a main and belay coming from each side and connected to a Rock Exotica UFO to help keep all of the attachment points ultra clean. A CMC MPD was used on each side to control the main lines and and i’D and Petzl ASAP used for the belay lines.

IMG_1383

A close up of the UFO on Rick Croft’s harness:

IMG_1385

Stand by for more frequent postings again. Thanks to everyone who keeps checking in!

While the Arizona Vortex is usually thought of as an industrial and wilderness rescue piece of equipment, it’s no secret that I think its full potential as a tool for the urban rescuer has not been fully explored. With that in mind, we are constantly trying (occasionally failing) to find out how to best use this tool to our advantage.  We’ve been working on different configurations of the Appalachian Wedge Pole (AWP) lately.

The first and perhaps the most useful version of the Wedge Pole is used to create anchors in a hallway where others might not exist. While no permanent name has been found yet, and because it appears to be bombproof, we’ve been calling it the Atomic Wedge Pole. Or Atomic Wedgie for short. As in: “Hey give him an Atomic Wedgie quickly, so we can get on with this rope rescue. ”  But again, no permanent name yet.

Below are some pictures we took during the discovery phase of these anchors, a scale model so to speak. They were loaded with a couple of guys giving it all they had, leaning into the load line. It was an initial test to see if the anchors would move at all. The next step in the process will be to load these with a one person load and operate a raising and lowering system. Then on to a two person load.

IMG_1348

A slightly more complex version that allows for a longer haul field that runs toward the edge.

IMG_1352

2 to 1 Wedgie

Some techniques might be setups in search of an application, the picture below being one such example. I envision using this above a hole in a hallway, where there are no other anchors present. This might be more of an industrial confined space setup, but it’s neat to see in action.

IMG_1334

These pictures above are of urban usage, but we developed the technique out on the rocks. Here are two pictures of the first AWP setups, one horizontal and one vertical, from when the idea first struck.

IMG_0420

IMG_0407

This last picture comes to us from the men of Group 2 on Rescue 1 with the Boston Fire Department. They constructed an Appalachian Lean-To and changed the direction of the haul line 90 degrees at the head resting on the floor. To counteract the resultant force that wants to lift the left leg away from the wall, they front tied the setup to an anchor spanning the doorway with two AZTEKs, one of which is doing the job of keeping that left leg in compression when it naturally wants to pull away from the wall because of the COD on the head. Good job guys!

sandy lasa

Enrollment is now open for our Modern Technologies in Rope Rescue. The class will be held March 30 and 31 at the Lancaster County Public Service Training Center in Lancaster County, PA at a cost of $280 per student.

This class covers multiple versions of the bowline along with some pretty god reasons to consider them, several uses of the AZTEK kit, a thorough introduction to the Two Tension Rope System concept with the MPD, and the use of the Arizona Vortex Artificial High Directional in some pretty typical urban setup configurations as well as some Rescue 2 Training exclusive uses of it in a few of the Appalachian Doortex configurations.

Below are some pictures from the last MTRR class in Lancaster. It was during this class that the Appalachian Flagpole was developed. The AF is designed to create a high point for grain silo rescue while not having to rely on the lightweight roof for support. A couple of the pictures show its first inception. The picture of the AF with the an MPD attached to the A frame head (next to the conex boxes) is where it is currently at. It is another high directional/anchor combo.

If you’re interested in seeing what’s on the cutting edge of rope rescue equipment and techniques, contact Kelly to reserve a spot in this popular class. Call 240-462-6610 or send an email to rescue-2@comcast.net

open enrollment March 2013

IMG_1219 IMG_1223 IMG_1233 IMG_1234 IMG_1235 IMG_1236 IMG_1238 IMG_1239 IMG_1241 IMG_1243 IMG_1247 IMG_1250 IMG_1265 IMG_1123 IMG_1109 IMG_1103 IMG_1122

Well it’s short notice, but we have had some significant interest in running another “Modern Technologies in Rope Rescue” class. So we’ve decided to add one more for the year.

We’ll be at the Lancaster County Public Service Training Center in Salunga- Landisville, PA on Dec 8-9 for this two day class covering a wide range of what’s new in the rope world. In particular, we will be working heavily with the CMC Rescue MPD (Multi-Purpose Device) and Two Tension Rope Systems. This system dramatically simplifies the rigging needed to execute the majority rope rescues.

We’re also going to be covering the use of  Arizona Vortex artificial high directional. While we will cover several traditional setup configurations, we  will also be showing the setup and use of the Appalacian Doortex in a couple of different configurations. Knotcraft, with a focus on the benefits of the bowline and it’s many variations, will also be covered in depth.

The cost of this 16 hour class is $280 per person. If you have any questions or would like more information, please give Kelly a call at 240-462-6610 or send an email to

rescue-2@comcast.net

…and the only prescription is more cowbell !

Just kidding, it’s more Doortex.

Continued work at the vacant buildings that double as the testing sites at R2T brought us to yet another variation of the Appalachian Doortex. We’re toying with the name Appalachian Slingshot (APS); again with the obvious shoehorning of East Coast stuff in to a rope topic. The APS concept was tested a few years ago when I hooked up and rappelled out of a window on it. The pictures below show us using it in an elevator shaft, but can be used out of a window or even for creating an anchor in a doorway.

The basic configuration for lowering:

This front tie is only needed when the APS is unloaded.

A change of direction was added to the haul line in order to make the hauling easier. We were able to pull down instead of up.

Here it is used to create a strong, simple doorway anchor. The AZTEK is there to pre-load the system.

Also under development is the stand alone use of leg sections sections as anchors in doorways. Here are a couple of pictures of two outer leg sections used to span a doorway and create anchor for the two MPDs used to raise and lower the load. We’ll be taking a serious look at this in the coming year to find out the limits of these leg sections.